Supervisor level
91
Payment system lock
To avoid tampering, a programme lock
can be set up in programme control. If
the lock is applied, the programme is
interrupted and payment credit is lost
as soon as the door is opened.
The time for the lock to be applied can
be adjusted to enable laundry to be ad-
ded.
- Off
- As soon as the programme starts
- 1minute after the start of the pro-
gramme
- 2minutes after the start of the pro-
gramme
- 3minutes after the start of the pro-
gramme (factory default)
- 4minutes after the start of the pro-
gramme
- 5minutes after the start of the pro-
gramme
FOC programmes
In coin mode, you can decide whether
the Drain/Spin programme can be used
for free.
Factory default: Off
Delete paid signal
The “Paid” signal in coin box mode
can be applied until the end of the
programme or discarded if the pro-
gramme is not started after 5minutes.
Factory default: Off
Debounce time
In coin mode, the debounce time for
the minimum payment signal that
must be applied can be adjusted.
- Factory setting: Short
For coin boxes where the falling coin
generates the paid pulse.
- Long
For central control units on a 230V
basis.