Supervisor level
88
Remote
Operating data relating to the washing
machine (e.g. fault messages or noti-
fications) is communicated externally.
Factory default: On
RemoteUpdate
The RemoteUpdate function is used to
update the software in your washing
machine.
RemoteUpdate is activated by default.
If you do not install a RemoteUpdate,
you can continue to use your washing
machine in the usual way. However,
Miele recommends installing Re-
moteUpdates.
Running a RemoteUpdate
If a RemoteUpdate is available for your
washing machine, it will be displayed
automatically when the operator level is
open.
You can choose to start the RemoteUp-
date immediately or wait until later. If
you select “Start later”, the prompt to
run the RemoteUpdate will be displayed
again the next time you switch on your
washing machine.
The RemoteUpdate can take a few
minutes.
Please note the following information
about the RemoteUpdate function:
- You will only receive a message when
a RemoteUpdate is available.
- Once a RemoteUpdate has been in-
stalled, it cannot be undone.
- Do not switch off the washing ma-
chine during a RemoteUpdate. Other-
wise, the RemoteUpdate will be abor-
ted and will not be installed.
SmartGrid
You can use the SmartGrid setting to
integrate your washing machine into
building energy management systems.
Factory default: Off
Controlled energy consump-
tion
In the Whites, Coloured items and
Minimum iron programmes, the ma-
chine will optimise the energy it uses if
Controlled energy consumption is selec-
ted.
Factory default: On
To Next Page
Loading...
Need help?
General
