Miele PWM 508 Mop Star 80 User Manual

Supervisor level
80
Main wash water
You can select the water type for the
main wash.
- Cold
Only cold water is used for the main
wash.
- Hot
Hot water is also added for the main
wash.
Hot water can only be added if the
wash temperature is above 30°C.
Programme durations will be longer if
the machine is not connected for hot
water; this may mean that the “Time
left” display is incorrect.
First rinse water
You can select the water type for the
first rinse in some programmes.
- Cold (factory default)
Only cold water is used for the first
rinse.
- Hot
Hot water is also added for the first
rinse.
Final rinse water
You can select the water type for the
last rinse in some programmes.
- Cold (factory default)
Only cold water is used for the final
rinse.
- Hot
Hot water is also added for the final
rinse (only possible for programmes
with a temperature of at least 60°C).
Low water pressure
If the water pressure is below 100kPa
(1bar), the programme will be can-
celled and the fault message Check
water inlet will appear.
If the on-site water pressure cannot be
increased, activating the setting Low wa-
ter pressurewill prevent the programme
from being cancelled.
Factory default: On
Pre-spin mops
In the standard mop programmes, wet
mops are spun briefly at the start of
the programme to remove surplus wa-
ter.
Factory default: On

Miele PWM 508 Mop Star 80 Specifications

General

Brand	Miele
Model	PWM 508 Mop Star 80
Category	Washer
Language	English