Miele PWM 507 Hygiene - Page 80

Miele PWM 507 Hygiene

80 pages

To Previous Page

To Previous Page

Loading...

M.-Nr. 11 434 810 / 00en-AU, NZ

PWM 507 Hygiene

Table of Contents

Default Chapter2
- Table of Contents2
Caring for the Environment6
Warning and Safety Instructions7
- Control Panel15
Operating the Washing Machine15
- Symbols on the Control Panel16
- Symbols in the Display17
- Main Menu18
- Sensor Controls and Touch Display with Sensor Controls18
- Examples on How to Operate the Appliance19
Using for the First Time20
1 Preparing the Laundry24
2 Loading the Washing Machine25
3 Selecting a Programme26
4 Selecting Programme Settings27
5 Adding Detergent28
- Adding Fabric Softener or Liquid Starch Separately29
- Adding Starch Separately29
6 Starting the Programme - the End of the Programme30
Delay Start31
Programme Chart32
- Special Programmes33
- Programme Packages34
Extra Options38
- Pre-Wash38
- Pre-Rinse38
- Soak38
- Rinse Plus38
Special Features in the Programme Sequence39
- Spinning39
- Anti-Crease39
Changing the Programme Sequence40
- Changing a Programme40
- Cancelling a Programme40
- Switching on the Washing Machine after an Interruption to the Power Supply40
- Adding or Removing Laundry41
Cleaning and Care42
- Cleaning the External Casing and Fascia Panel42
- Cleaning the Detergent Dispenser Drawer42
- Cleaning the Drum, Suds Container and Drainage System44
- Cleaning the Filters in the Water Inlet44
Problem Solving Guide45
- The Programme Does Not Start45
- Programme Cancellations and Fault Messages46
- A Fault Message Appears in the Display47
- An Unsatisfactory Wash Result48
- General Problems with the Washing Machine49
- The Door will Not Open50
- Opening the Door in the Event of a Blocked Drain Outlet And/Or Power Cut51
After Sales Service54
- Contact in Case of Fault54
- Optional Accessories54
Installation55
- Front View55
- Rear View56
- Installation Locations57
- Installation Notes57
- Transporting the Washing Machine to Its Installation Site58
- Installation Surface59
- Removing the Transit Bars59
- Refitting the Transit Bars61
- Aligning the Washing Machine61
  - Securing the Washing Machine to the Plinth62
- External Control Equipment62
  - Payment System62
- Water Connection63
  - Cold Water Connection63
  - Hot Water Connection64
- Drainage65
  - Drain Valve65
  - Drain Pump65
- Electrical Connection66
Technical Data67
Supervisor Level68
- Code-Based Access68
- Changing the Code68
- Opening the Supervisor Level68
- Exiting the Supervisor Level68
- Language69
- Brightness69
- Clock Display69
- Finish Tone Volume69
- Keypad Tone69
- Welcome Tone Volume69
- Fault Alarm69
- Memory69
- Anti-Crease70
- Suds Cooling70
- Display" Switch-Off Status70
- Machine" Switch-Off Status71
- Delay Start71
- Programme Name71
- Pre-Wash Water72
- Main Wash Water72
- First Rinse Water72
- Final Rinse Water72
- Low Water Pressure73
- Empty Sensor73
- Early Warning Counter73
- Water Level Cottons73
- Water Level Minimum Iron73
- Pre-Wash Temp. Cottons73
- Wash Time Pre-Wash74
- Wash Time Cottons74
- Wash Time Minimum Iron74
- Pre-Rinse Cottons74
- Pre-Rinse Minimum Iron74
- Pre-Wash Cottons/Min. Iron74
- Cottons Rinses74
- Minimum Iron Rinses75
- Disinfection Rinse75
- Programme Packages75
- Temperature Reduction75
- Disinfection Prog. Code75
- Auto Load Control76
- Hygiene76
- Automatic Dispensing76
- Peak Load Signal76
- Peak Load Prevention76
- Alternating Current77
- Heater77
- Payment System77
  - Settings for Payment Systems77
  - Feedback Signal to Pay System78
  - Clear Paid Signal78
  - Payment System Lock78
  - FOC Programmes78

Related product manuals

Preview: Miele PWM 507

Preview: Miele PWM 506 Mop Star 60

Miele PWM 506 Mop Star 60

Preview: Miele PWM 508 Mop Star 80

Miele PWM 508 Mop Star 80

Preview: Miele PWM 511

Preview: Miele PWM 514

Preview: Miele PWM 908

Preview: Miele PWM 307

Preview: Miele PWM 912

Preview: Miele PWM 300 SmartBiz

Miele PWM 300 SmartBiz

Preview: Miele PW 811

Preview: Miele PW 5065