en - Warning and Safety instructions
163
Chlorine and component damage
Frequent use of chlorine products increases the risk of damage to
components.
The use of substances containing chlorine, such as sodium hypo-
chlorite and chlorine bleach in powder form, can however result in
damage of the protective layer of stainless steel and corrosion on
components. Therefore, refrain from using substances containing
chlorine. Use oxygen-based bleaching agents instead.
If, however, chlorine bleaching agents are used, an anti-chlorine treat-
ment must always be carried out. Otherwise, both the washing ma-
chine components and the laundry may suffer persistent and irrepar-
able damage.
Anti-chlorine
treatment
Anti-chlorine treatment must be carried out immediately after chlorine
bleaching agents have been used. Hydrogen peroxide as well as oxy-
gen-based detergents and bleaching agents are suitable for anti-
chlorine treatment. The suds must not be drained in between.
Treatments with thiosulphates can result in gypsum-like deposits par-
ticularly when used in combination with hard water. This gypsum can
build up in the washing machine or cause incrustations on the laun-
dry. Treatment with hydrogen peroxide is recommended over treat-
ment with thiosulphates because hydrogen peroxide neutralises
chlorine.
The exact dispensing quantities and the treatment temperatures re-
quired must be set and tested on site in accordance with the dis-
pensing recommendations of the detergent and additive manufactur-
ers. The laundry must also be tested to check whether it contains any
active chlorine residues.
To Next Page
Loading...
