Display
The following are shown in the display:
– Programme Selection menu
– Programme duration and the
programme start and end time
– Fault and error messages
When a programme is selected, the
display is used to select:
– Different drying levels
–
Delay start
The
Settings
J menu is also operated
via the display.
- / + buttons
For altering the values shown in the
display:
- decreases the value or moves the
highlighting upwards
+ increases the value or moves the
highlighting downwards
OK button
For confirming the value selected and
choosing the next option.
m button
For selecting delay start.
You can also press this button during a
drying programme to check the
estimated programme end time or the
current time of day.
Estimated time remaining
When a programme is selected the
estimated drying time will appear in the
display. Please be aware that it is only
an estimate!
The following factors all affect the
estimated time remaining: Residual
moisture content after spinning; type of
fabric; size of load; room temperature;
fluctuations in power supply.
The electronics continually assess
conditions in the machine and adjust
the estimated time remaining for a more
accurate reading. Because of this the
time displayed can alter during the
course of a programme.
In the same way, the
Woollens hand
care
and
Smoothing
programmes can
finish earlier than expected if a certain
temperature is reached. This can
happen with particularly fine fabrics or
if items were partly dry beforehand.
Operating the tumble dryer
11
To Next Page
Loading...
