Fitting a plinth facing
The gap between the lower edge of the
tumble dryer plinth and the floor can be
closed up using a suitable kitchen
furniture plinth facing.
The tumble dryer plinth has a special
groove in which a plinth facing can be
fitted.
Plinth facing dimensions
Length
: 592 - 596 mm
Thickness
: 8 mm
Height (
H): The plinth facing height
must be calculated after aligning the
height of the machine with the screw
feet or after fitting the height adjustment
frames.
Installation
^
Calculate height (H) from the floor up
into the groove (on the underside of
the tumble dryer).
^
Cut the plinth facing to size.
^
Slide it into the groove.
Useful tip:
If the machine is fitted on a height
adjustment frame, you can use
double-sided adhesive tape on the
back of the plinth facing to secure it to
the height adjustment frame too.
Installation
42
To Next Page
Loading...
Need help?
General
