Miele WCE 330 - Removing the transit bars; Starting the calibration programme

Before using for the first time
18
2. Removing the transit bars
 Failure to remove the transit bars
can result in damage to the washing
machine and to adjacent cabinetry or
appliances.
Remove the transit bars as described
in “Installation and connection”.
The following message appears in the
display:
 Remove transit bars
 Confirm with the OK sensor.
3. Starting the calibration
programme
For optimum water and energy
consumption and excellent wash
results, it is important to calibrate the
washing machine.
To do this, the Cottons programme
must be run without
laundry and
without
detergent.
No other programmes can be started
until calibration has been carried out.
The following message appears in the
display:
Open  and run 'Cottons' 90°C without
laundry
 Touch the sensor until the OK
sensor lights up and confirm the
message with OK.
1:55
OK




90°
1400
 Turn on the tap.
 Touch the Start/Stop sensor.
The calibration programme is started. It
will take approximately 2hours.
At the end of the programme the
following message will appear in the
display:
Set up completed
 Reach under the door grip and pull
the door open.
Useful tip: For safety reasons, close the
door when the washing machine is not
in use. Otherwise there is a danger of
objects being placed inadvertently in
the drum. If these remain unnoticed and
were washed in the next load, they
could damage the laundry. An open
door is also a danger to pets and
children.
 Turn the programme selector to the
position.