Spinning
31
Final spin speed in the
programme
When a programme is selected, the
optimum spin speed for this wash
programme will appear in the display.
A faster spin speed can be selected for
certain wash programmes.
The highest selectable spin speed is
indicated in the table.
Programme rpm
Cottons 1400
Minimum iron 1200
Delicates 900
Woollens 1200
Silks 600
Shirts 900
QuickPowerWash 1400
Dark garments/Denim 1200
Outerwear 800
Proofing 1000
Drain/Spin 1400
Express 20 1200
Sportswear 1200
Automatic plus 1400
Separate rinse/Starch 1400
Clean machine 900
Rinse and interim spin
There is a spin cycle after the main
wash and between the rinses. A
reduction in the final spin speed will
also reduce the interim spin speed.
Omitting the final spin (Rinse
hold)
If Rinse hold is selected, the laundry
remains in the water following the final
rinse cycle. This helps prevent creasing
if the laundry is not going to be
removed from the drum immediately
after the end of the programme.
Set the spin speed .
To start the final spin:
The washing machine will display the
maximum spin speed possible. You can
reduce the spin speed.
Touch the Start/Stop sensor.
Ending the wash programme
Select this option if you want to remove
the laundry when it is dripping wet and
without having been spun.
Reduce the spin speed to 0.
Touch the Start/Stop sensor.
The water will be pumped away.
Omitting rinse and interim spin
and the final spin
Before the start of the wash
programme, reduce the spin speed to
0.
Touch the Start/Stop sensor.
After the last rinse, the water will be
pumped away and the anti-crease
phase will switch on.
In some programmes an additional rinse
is introduced with this setting.
To Next Page
Loading...
