Miele WCE 330 - Fault messages after a programme has been cancelled; Check drainage. See; Water intake. See; Service Waterproof syst. Turn off

Problem solving guide
54
Fault messages after a programme has been cancelled
Problem Possible cause and remedy
 Check drainage. See

The water outlet is blocked or restricted.
The drain hose has been fixed too high.
 Clean the drain filter and the pump.
 The maximum drain height is 1m.
 Water intake. See

The water inlet is blocked or restricted.
 Check whether the tap is turned on properly.
 Check whether the inlet hose is kinked.
 Check whether there is sufficient water pressure.
The filter in the water inlet is blocked.
 Clean the filter.
The drain pump is activated for 2 minutes. The
washing machine door is then released. Wait for the
drain pump to stop before switching the machine off.
  Service
Waterproof syst.
Turn off 
The water protection system has reacted.
 Turn off the tap.
 Call Miele.
  Service Fault F
There is a fault.
 Disconnect the washing machine from the mains
electricity supply, either by switching it off at the
wall socket and withdrawing the plug, or by
disconnecting it at the circuit breaker.
 Wait at least 2 minutes before reconnecting the
washing machine to the mains electricity supply.
 Then switch the washing machine on again.
 Restart the programme.
If the fault message appears again, contact Miele.
To switch off the fault message: Turn the programme selector to the  position
and switch the washing machine off.