Spinning
28
Final spin speed in wash
programmes
When a programme is selected, the
sensor control for the optimum spin
speed for that programme will be
brightly lit up in the control field.
A faster spin speed can be selected for
certain wash programmes.
The highest selectable spin speed is
indicated in the table.
Programme rpm
Cottons 1400
Cottons 1400
Minimum iron 1200
Delicates 900
Woollens 1200
Shirts 900
QuickPowerWash 1400
Express 20 1200
ECO 40-60 1400
Proofing 1200
Drain/Spin 1400
Separate rinse/Starch 1200
Rinse and interim spin
There is a spin after the main wash and
between the rinses. A reduction in the
final spin speed will also reduce the
interim spin speed. If a spin speed of
less than 700 rpm is selected for the
Cottons programme, an additional rinse
is introduced.
Selecting Rinse hold (final spin)
Touch the sensor control (Rinse
hold).
The laundry is not spun after the final
rinse and remains in the rinse water.
This helps to prevent creasing if the
laundry is not going to be removed from
the drum immediately after the end of
the programme.
Ending a programme with a spin
cycle
The sensor control for the optimum spin
speed lights up on the control field. You
can change the spin speed.
Touch theStart/Add laundry sensor
control.
Ending a programme without a spin
cycle
Reduce the spin speed to 0.
Touch theStart/Add laundry sensor
control.
To omit rinse and interim spin
and the final spin
Touch the sensor.
After the last rinse, the water will be
pumped away and the anti-crease
phase will switch in.
In some programmes an additional rinse
is introduced with this setting.
To Next Page
Loading...
Need help?
General
