Installation
*INSTALLATION*
68
Water drainage
The suds are drained through a drain
pump with a 1m high delivery head. For
the water to drain freely, the hose must
be free of kinks.
If required, the hose can be extended to
a length of up to 5m. Accessories are
available from your Miele dealer or from
the Miele Customer Service
Department.
For drain heights of more than 1m (up
to a maximum delivery head of 1.8m), a
replacement drain pump will need to be
fitted. Please contact Miele for advice.
For a drain height of 1.8m, the hose
can be extended to a length of up to
2.5m. Accessories are available from
your Miele dealer or from the Miele
Customer Service Department.
Drainage options:
1. Directed into a sink or basin:
Please note:
– Hook the hose over the edge and
secure it.
– If the water is pumped into a
washbasin, make sure that it can
drain away freely. Otherwise there
is a risk of water overflowing or of
some of the drained water being
sucked back into the machine.
2. Connected securely to a plastic drain
pipe with a rubber nipple (there is no
need to use a siphon).
3. Connected securely to a floor drain
(gully).
4. Connected securely to a washbasin
with plastic nipple.
Fitting the elbow
Use the elbow supplied to stop the
drain hose from slipping.
Attach the elbow to the drain
hose.
Place the end of the drain hose in a
sink.
Use a strap and the eye to stop
the elbow from slipping.
To Next Page
Loading...
Need help?
General
