Programmable functions
75
Sensor tone
Each touch of a sensor control is
confirmed with an audible tone.
Selection
= Sensor tone is switched off
= Sensor tone is set to normal
volume
= Sensor tone is set to loud
volume
Lock code
The lock code prevents the washing
machine being used without your
knowledge.
When the code has been activated, you
have to enter a code after switching the
washing machine on. Otherwise the
washing machine cannot be operated.
Options
= Lock code switched off
= Lock code is switched on
Using the washing machine with a
lock code
The code is 125 and cannot be altered.
Switch on the washing machine.
appears in the time display and
the and sensors light up.
Touch the sensor.
appears in the time display.
Confirm the number with the Start/
Add laundry sensor.
The first number was saved and you
can now enter the second number
using the and sensors.
Also enter the second and third
numbers and confirm the numbers
with the Start/Add laundry sensor.
The lock is released and a wash
programme can now be selected and
started.
Control panel switch-off
status
To save energy the time display and
sensors will go out after 10minutes,
and only the Start/Add laundry sensor
will flash slowly.
Options
= Off
The time display and sensors
will remain lit up while the
washing machine is switched
on
= On
The time display and sensors
will switch off after 10minutes
if the programme is started.
However; the time display and
sensors will remain lit up for
10minutes after a delay start
time has elapsed, after the end
of the programme or at the end
of the anti-crease phase.
To Next Page
Loading...
Need help?
General
