Need help?Do you have a question about the Mikado Logo 400 SE and is the answer not in the manual?
General| Brand | Mikado |
|---|---|
| Model | Logo 400 SE |
| Type | Helicopter |
| Battery | 6S LiPo |
| Skill Level | Advanced |
Assembly of the main frame component for the helicopter.
Installation of the bearing case into the main frame assembly.
Steps for securely attaching the motor to the helicopter frame.
Assembly of the main gear hub component.
Procedure for setting the correct gear backlash for optimal performance.
Instructions for mounting and assembling the tail rotor shaft.
Attaching the vertical fin to the tail boom assembly.
Installation and alignment of the tail pitch slider mechanism.
Steps for assembling the tail rotor lever component.
Assembly of the tail rotor hub, including greasing the bearing.
Mounting the tail boom holder and orienting the drive belt.
Attaching the tail drive pulley and checking belt tension.
Connecting the tail control rod with ball links.
Mounting the tail assembly and adjusting gear backlash.
Attaching the tail rotor blades and ensuring smooth movement.
Securing the tail boom brace with ball links at a 90-degree offset.
Selection and attachment of servo arms for control surfaces.
Linkage measurements for 3D pitch range (-12° to +12°).
Mounting different sizes of tail rotor servos on side-frames.
Installation of the elevator servo.
Connecting the elevator linkage to the swashplate.
Securing the helicopter canopy using fixing bolts.
Installation of the aileron servo on the left side-frame.
Installation of the aileron servo on the right side-frame.
Connecting the aileron linkage to the swashplate assembly.
Exploded view and parts list for the chassis assembly.
Exploded view and parts list for the rotor head assembly.
Exploded view and parts list for the tail boom and rotor.
To Next Page
