Mikado LOGO 400 - Assembly and R;C Equipment Tools

Manual LOGO 400 Page 3 ©Mikado Modellhubschrauber
Speed-
controller
Tools for Assembly & R/C Equipment
Radio with Heli-Software
4x Mini Servos (Graupner DS361
or Graupner C341)
Receiver Battery
(Sanyo AR500)
Battery
Receiver (Graupner DS 19
or SMC 19 SPCM)
Gyro (Futaba GY240
or GY401)
Fast Charger
(Schulze isl 6-330d or isl 6-636+)
Motor + Speed Controller (check the Mikado
webpages for recommended motors)
Alle shown products are examples. You may use different brands.
BEC, replaces
receiver battery
Scissors
Rubber Hammer
Drill with
1.5mm bit
(.059 in)
Marker
Screwdrivers
(plus and minus)
Hex Wrenches
1.5/2.0/2.5/3.0 mm
(.055/.079/.098/.118 in)
Ball
link
pliers
Threadlock
Ball
link
pliers
Grease
Pitch Gauge