Milesight VS133 - Page 34

34
VS133 supports to configure the device via downlink commands. Application port is 85 by
default.
Channel
Type
Description
ff
10 (Reboot)
ff (Reserved)
03 (Reporting Interval)
2 Bytes, unit: s
04 (Confirm Mode)
00: disable, 01: enable
05 (LoRaWAN
®
Channel Mask)
Byte 1: Channel index range
01: 0-15
02: 16-31
03: 32-47
04: 48-63
05: 64-79
06: 80-95
Byte 2-3: indicate disable or enable via
every bit, 0=disable, 1=enable
40 (ADR)
00: disable, 01: enable
41 (Application Port)
1 Byte, default is 85
42 (Wi-Fi)
00: disable, 01: enable
43 (People Counting Periodic Report)
00: disable, 01: enable
44 (People Counting Trigger Report)
00: disable, 01: enable
51 (Clear the accumulated counting)
ff (Reserved)
Note: After changing any parameter of LoRaWAN
®
settings, the device will re-join the network.
Example:
1. Disable Wi-Fi.
ff4200
Channel
Type
Value
ff
42 (Wi-Fi)
00: disable
2. Set AU915 or US915 channel mask as 8-15.
ff0501ff00 ff05020000 ff05030000 ff05040000 ff05050000
Channel
Type
Value
ff
05
(Set Channel Mask)
01: Channel index 0-15, ff00 => 8-15 is enabled
02-05: Channel index 16-79, 0000 => all disabled
3. Reboot the device.
ff10ff
Channel
Type
Value