Milesight WS202 - Lorawan Settings

8
1) Check the location of the smartphone NFC area and it’s recommended to take off the phone
case.
2) If the smartphone fails to read/write configurations via NFC, move the phone away and back
to try again.
3) WS202 can also be configured by ToolBox software via a dedicated NFC reader provided by
Milesight IoT, you can also configure it via TTL interface inside the device.
3.2 LoRaWAN Settings
Go to Device > Setting > LoRaWAN Settings of ToolBox App to configure join type, App EUI, App
Key and other information. You can also keep all settings by default.
Parameters
Description
Device EUI
Unique ID of the device which can also be found on the label.
App EUI
Default App EUI is 24E124C0002A0001.
Application Port
The port used for sending and receiving data. The default port is 85.
Join Type
OTAA and ABP modes are available.
LoRaWAN Version
V1.0.2, V1.0.3 are available.
Work Mode
It’s fixed as Class A.
Application Key
Appkey for OTAA mode, default is 5572404C696E6B4C6F52613230313823.
Device Address
DevAddr for ABP mode, default is the 5
th
to 12
th
digits of SN.