Miller M-10 - Replacing Gun Switch and Head Tube

OM-1035 Page 4
6. Replacing Switch And/Or Head Tube
Ref. ST-800 795-C
Tools Needed:
3/4 in
Remove handle
locking nut.
Slide handle.
Secure head
tube in vice.
Loosen jam nut.
Remove from vice
and turn head tube
out by hand.
For M-25 and M-25M models only, install existing
shock washer onto new head tube.
Hand-tighten head tube into cable connector.
Place head tube in vice and tighten until
nuts are tight.
Remove from vice. Reposition handle and install
switch housing. Secure with handle locking nut.
Y Turn Off welding power source
/wire feeder and disconnect gun.
Remove switch housing. Install new switch
and connect leads (polarity is not important).
Reassemble in reverse order. If replacing
head tube, continue to end of figure.
1
3
2
4
5
8
6
7