Miller Titanium 9400 - User Manual

®
Auto-Darkening Helmets
Model: TitaniumtSeries w/Infotrackt
OM-256 016A
2012−03
To help us serve you better, go to www.MillerWelds.Com/Register

Summary

Welding Helmet Safety Precautions

1-2. Arc Welding Hazards

Details hazards from arc rays, noise, fumes, and gases.

1-4. Lens Shade Selection Table

Operating Instructions: Titanium 7300 & 9400 Series

3-2. Helmet Controls

Identifies and explains main helmet display controls.

3-3. Auto On;Off Button And Grind Mode; Low Battery Light

3-4. Mode Control Button

Details using the Mode Control button for different welding modes.

3-5. Variable Shade Control

Explains adjusting lens shade for different welding conditions.

3-6. Lens Delay Control

3-7. Sensitivity Control

Explains adjusting lens sensitivity to arc detection.

3-8. Typical Lens Adjustment Procedure

Provides step-by-step guide for adjusting lens settings.

3-9. Info Control Button

Adjusting Headgear

5-1. Adjusting Headgear On Titanium 7300 And 9400 Series Helmets

Details headgear adjustment for proper fit on 7300/9400 models.

5-2. Adjusting Headgear On Titanium 1600 And 1600 i Series Helmets

Explains headgear adjustment for 1600/1600i series helmets.

Replacing Grinding Shield or Lens Covers

6-1. Replacing Grinding Shield On 9400 i And 1600 i Helmets

6-2. Replacing Lens Covers On Quick Release Helmets

Replacing the Battery

7-1. Replacing The Battery In Titanium 7300 And 9400 Series Helmets

Step-by-step guide for battery replacement in 7300/9400 models.

Maintenance

Maintenance

Troubleshooting

Limited Warranty

Limited Warranty

Miller Titanium 9400 Specifications