What to do if digital meter is not working properly on Miller XPS 350 Welding System?
If the digital meter on your Miller Welding System is not working properly, have a factory Authorized Service Agent check the control board PC1 and its connections, and replace if necessary. Additionally, have them check the meter display board PC2 settings and connections, and replace if needed.
How to troubleshoot no weld output on a Miller XPS 350 Welding System?
If your Miller Welding System isn't providing any weld output and appears completely inoperative, first ensure the line disconnect switch is in the On position. Then, check and replace the line fuses if necessary, or reset the circuit breaker. Also, verify that the input power connections and jumper links are properly configured. If these steps don't resolve the issue, have a factory Authorized Service Agent check the continuity of the power switch S1 and replace it if needed.
What to do if Miller Welding System has limited weld output?
If your Miller Welding System has limited weld output and a low open circuit voltage, check the input power connections. Also, check the jumper links position. Clean and tighten all weld output connections.
Why Miller Welding System has no weld output but pilot light is on?
If your Miller Welding System shows no weld output but the pilot light PL2 is on, the unit may have overheated. Allow the unit to cool down.
General| Input Voltage | 208/230/460 V |
|---|---|
| Input Phase | 3-Phase |
| Input Frequency | 50/60 Hz |
| Output Current Range | 5 - 425 A |
| Duty Cycle | 60% |
| Welding Processes | MIG, Flux-Cored, Stick |
| Wire Feed Speed | 50 IPM |
| Output Voltage Range | 10 - 38 VDC |
To Next Page