Milnor MWF63C Series Maintenance Guide

ii
Pellerin Milnor Corporation
3.1.7 How To Show the Maintenance On a Calendar ....................................................23
3.2 Maintenance Components—Machines and Controls Group ...........................................24
3.2.1 How to Examine V-belts and Pulleys....................................................................24
3.2.2 Inverters.................................................................................................................26
3.2.3 Chemical Devices..................................................................................................26
3.2.4 Water and Steam Devices......................................................................................27
3.2.5 How to Examine Compressed Air Mechanisms....................................................29
3.2.6 Photoeyes and Proximity Switches .......................................................................32
3.2.7 How to Do a Test of Emergency Stop Mechanisms..............................................32
3.3 Maintenance Components—Large Extractors ................................................................34
3.3.1 Lubricant Maintenance for Grease-filled Drive Bearings .....................................34
3.3.2 Lubricant Maintenance for Non-drive Components..............................................34
3.3.3 About the Shock Absorbers...................................................................................35
Figures
Figure 1 Machine Data Plate....................................................................................................4
Figure 2 Incorrect Configurations That Let the Chemical Supply Go In the Ma-
chine by a Siphon......................................................................................................12
Figure 3 Incorrect Configurations That Let the Chemical Supply Go In the Ma-
chine by Gravity........................................................................................................13
Figure 4 Examples of Manifolds for Chemical Tubes. Your equipment can look
different.....................................................................................................................13
Figure 5 A Configuration that Prevents Flow in the Machine When the Pump is
Off (if the chemical tube and tank have no pressure) ...............................................14
Figure 6 Motor Grease Maintenance Conditions ....................................................................22
Figure 7 Belt and Pulley Conditions To Look For .................................................................24
Figure 8 How to Adjust Belt Tension On a Machine That Uses Spring Tension ...................25
Figure 9 Electric Box and Inverter. These are examples. Your machine can look
different.....................................................................................................................26
Figure 10 Chemical Inlet Manifolds for Chemical Pump Systems. See caution
statement below. These are examples. Your machine can look different. ................27
Figure 11 Soap Chute and Optional 5-compartment Supply Injector. These are ex-
amples. Your machine can look different. ................................................................27
Figure 12 Air Tube for the Water Level Sensor. These are examples. Your ma-
chine can look different. ...........................................................................................28
Figure 13 Water Pressure Regulator for Chemical Flush. These are examples.
Your machine can look different...............................................................................28
Figure 14 Steam Inlet Strainer. These are examples. Your machine can look
different.....................................................................................................................29
Figure 15 Compressed Air Inlet Strainers. These are examples. Your machine can
look different.............................................................................................................29
Figure 16 Self-purging Air Line Filter to Remove Moisture and Other Contamina-
tion. These are examples. Your machine can look different.....................................30
Figure 17 Compressed Air Mechanisms These are examples. Your machine can
look different. ...........................................................................................................31
Figure 18 Speed Sensor (photoeye) on Some Machines...........................................................32
Contents

Milnor MWF63C Series Specifications

General

Brand	Milnor
Model	MWF63C Series
Category	Washer
Language	English