– 3.74 –
Detect a registration mark automatically after the sheet is detected [SEARCH
MARK]
Set the automatic registration mark search function performed after the sheet is detected.
If both of the registration mark detection and the registration mark search is valid, the function will
search the registration mark automatically after the sheet is detected.
From the original point after detecting the sheet, it scans the set scan width back and forth at half
intervals of the registration mark size. Then, when it finds a segment, a point or a printed material,
the registration mark detection will be performed.
If the vertical line and the horizontal line are detected properly, it is reconginzed as a registration
mark and the original point setting will be performed.
Procedure
1) Confirm the plotter is in the local mode.
2) Press the [FUNCTION] key.
3) Select [SET UP] by pressing the jog key [
]
[ ].
4) Press the [ENTER/HOLD] key.
5) Select [SEARCH MARK] by pressing the jog
key [
] [ ].
CT1 020 050 0.30
SQUARE CUT <ENT>
SET UP <ENT>
SEARCH MARK<ent>
FUNCTION
Scan width
Half of registration
mark size
Origin position
after detecting
the sheet
To Next Page
Loading...
