– 3.41 –
Method to detect registration marks
Registration marks are detected in two different ways; full-automatic detection and semi-automatic
detection. Use the semi-automatic function when no TP1 is at the bottom right of the sheet, or using
FineCut attached to cutting software.
* If the sheet is curling up, straighten the sheet.
* Use a sheet which has neither stains nor images in the area (A) located
between TP1 and TP2 and in the area (B) located between TP1 and TP3.
Confirm sheet slope by a light pointer
Pull clamp lever down and the pinch rollers upholds to light the light pointer. The carriage is manu-
ally moved from side to side.
Pull clamp lever down, and manually move the carriage between TP and TP3 to confirm the sheet
slope with a line of the light pointer. Adjust the sheet slope
according to the line.
* In case no action performed for five minutes after pulling clamp lever down,
the light pointer will automatically go out.
TP1
Sheet slope
TP3
Moving line
of the light pointe
To Next Page
Loading...
