© 2014 MIMAKI ENGINEERING CO.,LTD. 4.3 P.11
4.3 Mounting the Accessories
R.1.0
1
2
3
4
5
6
7
9. Insert the cable of the take-up device into the connector on the
bottom surface of electric unit.
10. Using the screw (M5x15), connect the ground line to the right
leg of the take-up device unit.
11. Fix the cable of the take-up device unit with the cable clamps
(x2).
INSTALLATION GUIDE > Printer Assembly > Mounting the Accessories
Model
CJV300
Issue
2014.09.01
Revised F/W ver.
1.30
Remark
1.0
To Next Page
Loading...
