MIMAKI CJV330 Series - Installation Space

- 18 -
4. Add register marks and ID data.
(1) Select the register mark size.
• [Type1 ], [Type2 ]
(2) Enter the register mark size.
(3) Check [ID Cut].
• Register marks and ID data are added to the data.
• For ID Cut data sent from FineCut, the [ID Cut] check box is already checked. You can not
uncheck it.
(4) Select [Location] of register mark.
• Individual: Register marks and ID data are added for each data.
• Whole: Register marks and ID data are added to enclose all copied data.
(5) [Offset] is set when [Whole] is selected in (4).
• Offset: Data and margin of register mark
5. Output data with RasterLink( P.9 "Print data.")
• Data with ID will be printed.
6. Create another data and repeat Step1 to Step5.
7. Set the printed media on Supported Print & Cutters.
(1)
(2)
(3)
(4)
(5)
Offset
Offset
OffsetOffset