6
3
Clean the cap.
• Wipe off any ink on the cap rubber and the cap rubber cover
using a clean stick soaked in the F-200/LF-200 maintenance
liquid.
4
Take the PR-200 maintenance liquid (C-ML013-Z-
B2-1-KW) and fill only the cap of the head
equipped with PR-200 with it until it is full.
• Fill the cap with the cleaning solution just before the solution
overflows from the cap.
5
Press the ENTER key to start nozzle cleaning.
• The screen on the right is displayed during cleaning.
• After cleaning, return to the Step 1 screen.
6
Execute head cleaning (HARD) once for the head
equipped with PR-200.
• Refer to the Step 10 of Chapter 4 “Washing of Head nozzle (When
Using the PR-200 maintenance liquid)” of the user’s manual to perform
the operation.
7
Check the nozzle status by performing a test print.
• When the nozzle clogging occurs, execute nozzle cleaning (HARD) again then check the nozzle status.
• When cleaning the wiper, bracket, cap rubber, and
cap rubber cover, be sure to use the F-200/LF-200
maintenance liquid, and do not use the PR-200
maintenance liquid (C-ML013-Z-B2-1-KW).
• Wipe it off properly so that there is no residual F-
200/LF-200 maintenance liquid.
Cap rubber
Cap rubber
cover
PLEASE WA I T
00 : 00
** CLEAMING **
PLEASE WA I T
CLEAN I NG
HARD [ENT]
SELECT HEAD
_2
To Next Page
Loading...
