MIMAKI JFX500-2131 - Setting Glossy Finish for Emboss Print

- 23 -
Setting glossy finish for Emboss Print
If you set just Emboss Print, the finish will be matte. To obtain a glossy finish, you must reate a Glossy clear ink
job, separate from the Emboss Print clear ink job.
1.
Referring to P. 7~ “Decide the way the clear ink is to be printed”, create 1
color job and 2 clear ink jobs.
2.
Choose the job of emboss printing from
the job list.
• Refer to [c.Setting Emboss Print] and set the thick
print.
• In the case of [Printing the clear ink over the whole
of the color image][B.Printing the clear ink onto the
valid pixels of the color image ]:
Turn off “Composite automatically” in Special plate
printing before creating the clear ink job.
Otherwise it will not be possible to create multiple
clear ink jobs, since a special plate cannot be
made from a composited job.
Carry out the above procedure 2 times to create
the 2 clear ink jobs.
• In the case of [Printing a special clear ink image]:
Carry out the “Setting mono color replacement”
procedure, then carry out the following procedure
to duplicate the job.
1. Select the clear ink job.
2. Click the “Duplicate” icon.
3. Make the settings as follows.
(1) [Special color]：Ink = Clear
Clear = Select “100%”.
(2) [Created area]: Select “Valid Pixel”.
(3) [Composite automatically]: OFF
(4) Click the [Create] button.
Turn OFF
(1)
(3)
(4)
(2)