2. Configuring the RIP PC
10
5
On the Networking tab, select the [Internet Protocol Version 4 (TCP/IPv4)] connection item,
and then click [Properties].
6
Configure the network settings.
• Configure the network settings of the RIP PC according to the network settings of the control PC.
• For more information regarding the network settings of the control PC and the RIP PC, please
contact your network administrator.
7
Restart the RIP PC to apply the settings.
8
Confirm that the connection has been established.
• First, connect the RIP PC and the control PC via a LAN cable.
• Please refer to the following for more details regarding LAN cable connection.
"Connecting to a Local Network"(P. 4)
To Next Page
Loading...
