The procedures from the ink and media preparation to drawing
and the setting procedures are described.
User type ........................................ 2-2
Set items registrable to User type ..... 2-2
Using the registered user type .......... 2-2
Workflow......................................... 2-3
Turning the power ON/OFF........... 2-4
Turning the power ON ....................... 2-4
Turning the power OFF ..................... 2-5
Setting medias ............................... 2-6
Useable medias ................................ 2-6
Adjusting the head height .................. 2-6
Setting a roll media ...........................2-8
Take-up device (Except Type B) ..... 2-13
Setting leaf media ........................... 2-14
Changing the printing origin ............ 2-16
Preparing Heaters........................ 2-18
Changing temperature settings of
Heater ............................................. 2-18
Confirming the Heater temperature . 2-19
Test printing ................................. 2-20
Perform test printing with the
normal test pattern .......................... 2-21
Perform test printing with the test
pattern for checking white ink ......... 2-22
Check warning of white nozzle status
(Only when using SS21 white ink) .. 2-23
Head Cleaning .............................. 2-24
About head cleaning ....................... 2-24
Perform head cleaning depending
on the test printing result ................ 2-25
Perform spot color maintenance ..... 2-25
Drawing data................................. 2-30
Starting the print ............................. 2-30
Stopping the print temporarily ......... 2-31
Erasing the received data
(Data clear) ..................................... 2-31
Cutting a media ............................... 2-32
CHAPTER 2
Basic Operations
To Next Page
Loading...
