Setting media compensation
3-7
3
Convenient use
When you need to correct the media feed during printing
The media feeding amount can be corrected even in the remote mode or when printing image data.
1
Press the key in the
remote mode.
2
Press the key.
3
Enter the correction amount with
and key.
• Correction amount : -500 to 500
• The value entered here will be reflected on the correction amount immediately.
4
Press the key.
• The value entered here will be invalid when pressing key in stead of key.
5
Press the key.
• The changed value is registered.
• The value entered here will be valid temporarily when pressing key in stead of
key. (If performing media detection again or turning OFF the power supply, the
correction value will be cleared.)
To Next Page
Loading...
