MIMAKI SWJ-320 S2 - Page 139

© 2013 MIMAKI ENGINEERING CO.,LTD. 6.3.2 P.1
R.1.1
1
2
3
4
5
6
7
8
6.3.2 Y-axis Motor
 Work procedures
1. Turn off the main power supply.
2. Loosen the screws to make the belt tension free.
3. Remove the YM top plate together with the bearing.
4. Remove the YM stud.
5. Disconnect the connector.
6. Remove the Y-axis motor together with the YM-BKT.
7. Remove the YM-BKT from the Y-axis motor.
8. Reverse the disassembly procedure for reassembly.
Turn the main power OFF when turning the power OFF. It is very dangerous if sleep mode func-
tions mistakenly during the operation.
Proceed with the work after well confirmed the following processes in advance.
 3.2.2 Replacement of the Y-axis Motor
Screw
YM top plate
YM stud (x2)
Screw
YM-BKT
Connector
YM-BKT
Y-axis motor
MAINTENANCE MANUAL > Disassembly and Reassembly > Drive System > Y-axis Motor
Model SWJ-320S Issued 2012.07.19 Revised 2012.08.17 F/W ver Remark
1.1
Rev.