MIMAKI TS34-1800A - Cutter Blade Replacement

© 2011 MIMAKI ENGINEERING CO.,LTD. 5.1.7 P.1
1
2
3
4
5
6
7
8
R.1.0
5.1.7 [MOTOR TEST] Y SERVO MOTOR
 Function
Operation test of Y-axis motor is executed.
 Operation Procedures
Step Item Description Remarks
1 Speed designation [], [] : Selects speed.
Set value: 1 – 1500 mm/s (unit: 1 mm/s)
[], []:
Selection of item 2 – 4
2 Acceleration designation [], [] : Selects acceleration.
Set value: 0.05 – 2.00 G (unit: 0.05 G)
3 Moving amount designation [], [] : Selects moving amount.
Set value: 1 mm – paper length (width) (unit: 1 mm)
When media is not detected: 1 mm-Mechanical
limit size
4 Cap OFF (Only after media
detection)
5 Test start [ENTER]: Repeats reciprocating motion in the Y direction
with designated conditions.
6 End [END] : Returns to the motion starting position and executes
capping to end the test.
MAINTENANCE MANUAL > Test Items > Test Function > [MOTOR TEST] Y SERVO MOTOR
Model TS34-1800A Issued 2011.10.17 Revised F/W ver 1.20 Remark
1.0
Rev.