© 2011 MIMAKI ENGINEERING CO.,LTD. 6.2.2 P.1
1
2
3
4
5
6
7
8
6.2.2 Head Unit
Work procedures
1. Select [DAMPER DISCHG] from the operation menu.
2. Check discharging of ink in the damper visually and then press
the [END] key.
3. Turning the power off.
4. Pull out the head FFC assy and head memory cable assy from
the slider PCB assy through the top where the wiring cover
removed.
5. Move the print head carriage onto the platen to make your work
easy.
6. Loosen the screws at two locations on the right and left to
remove the P cover BKT.
7. Remove the damper lock spring.
<LOCAL. 1> [#01]
FUNCTION
#ADJUST <ENT>
#ADJUST
DAMPER DISCHG <ent>
[END]
DAMPER DISCHG
START :ent
Do not touch the film of the damper assy.
Remove the damper lock spring before removing
the damper joint Assy.
If the damper joint Assy is moved with the damper
lock spring, the damper lock spring loses its perfor-
mance.
R.1.0
MAINTENANCE MANUAL > Disassembly and Reassembly > Ink-related Parts > Head Unit
Model
TS34-1800A
Issued
2011.10.17
Revised F/W ver
1.20
Remark
1.0
To Next Page
Loading...
