MIMAKI TS34-1800A - Page 183

© 2011 MIMAKI ENGINEERING CO.,LTD. 6.3.2 P.1
1
2
3
4
5
6
7
8
6.3.2 Y-axis Motor
 Work procedures
1. Remove the following covers.
• KB Cover
• Right Cover
2. Remove the KB BKT screws, disconnect the connector and
then remove the keyboard assy.
3. Manually move the print head carriage on the platen and
remove the D-BKT cover.
Turn the main power OFF when turning the power OFF. It is very dangerous if sleep mode functions
mistakenly during the operation.
Y-axis Motor
KB BKT
R.1.0
MAINTENANCE MANUAL > Disassembly and Reassembly > Drive System > Y-axis Motor
Model TS34-1800A Issued 2011.10.17 Revised F/W ver 1.20 Remark
1.0
Rev.
D BKT Cover