MIMAKI TS34-1800A - Page 202

© 2011 MIMAKI ENGINEERING CO.,LTD. 6.4.6 P.1
1
2
3
4
5
6
7
8
6.4.6 Station PCB Assy
 Work procedures
1. Remove the following covers.
• KB Cover
• Right Cover
2. Disconnect all cables from PCB.
3. Remove the screws and then remove the station PCB assy.
4. Reverse the disassembly procedure for reassembly.
Turn the main power OFF when turning the power OFF. It is very dangerous if sleep mode functions
mistakenly during the operation.
Station
Station PCB Assy
R.1.0
MAINTENANCE MANUAL > Disassembly and Reassembly > Electrical Parts > Station PCB Assy
Model TS34-1800A Issued 2011.10.17 Revised F/W ver 1.20 Remark
1.0
Rev.