MIMAKI TS34-1800A - Page 216

© 2011 MIMAKI ENGINEERING CO.,LTD. 6.4.17 P.1
1
2
3
4
5
6
7
8
6.4.17 Detector Assy, I/C, Y
 Work procedures
1. Remove the relevant cartridge guide.
• See "6.4.16 ID Contact PCB CN032 Assy".
2. Remove the screw, release the hook and then remove cartridge
frame.
3. Remove the detector assy, I/C, Y from the cartridge guide.
4. Reverse the disassembly procedure for reassembly.
Exist/non-exist Sensor
Near End Sensor
Releasing of
the hook
Cartridge Frame
Near End Sensor
Exist/non-exist Sensor
R.1.0
MAINTENANCE MANUAL > Disassembly and Reassembly > Electrical Parts > Detector Assy, I/C, Y
Model TS34-1800A Issued 2011.10.17 Revised F/W ver 1.20 Remark
1.0
Rev.