MIMAKI TS34-1800A - Page 244

© 2011 MIMAKI ENGINEERING CO.,LTD.
8.2.2 P.1
1
2
3
4
5
6
7
8
R.1.0
MAINTENANCE MANUAL > Operation Flow > Print Mode > SETUP
Model TS34-1800A Issued 2011.10.17 Revised F/W ver 1.20 Remark
1.0
Rev.
8.2.2 SETUP
FUNCTION
SETUP <ENT>
SETUP
SELECT :TYPE.1
[1]MEDIA COMP.
PRINT START :ent
PRINTING
PLEASE WAIT
[1]
MEDIA COMP. <ent>
[1]MEDIA COMP.
VALUE = 0
:-255 to 255
[1]PRINT MODE
PASS <ent>
[1]PRINT MODE
PASS : HOST
[1]
PRINT MODE <ent>
FAST,STANDARD,FINE
[1]PRINT MODE
SCAN FEED <ent>
[1]PRINT MODE
SCAN FEED :HOST
STANDARD,HI SPEED
[1]PRINT MODE
SCAN DIRECITON <ent>
Uni-D
[1]PRINT MODE
LOGICAL SEEK <ent>
[1]PRINT MODE
LOGICAL SEEK :HOST
ON,OFF
SCAN :DrawEnd
HOST : HOST
[1]
DRYING TYME <ent>
0to 19,9s, 0 to 999s
[1]AUTO CUT
SETUP :HOST
[1]
AUTO CUT <ent>
:ON,OFF
[1]PRINT MODE
ScanDIRECTION :Bi-D
[1]PRE-FEED
SETUP :HOST
[1]
PRE-FEED <ent>
:ON,OFF
TYPE.1 to TYPE.4
Disabled when using the tension
bar of heavy-duty take-up device
[FUNCTION],
[] / []
[FUNCTION],
[] / []
[FUNCTION],
[] / []
[FUNCTION],
[] / []
[FUNCTION],
[] / []
[ENTER]: Drawing
[END]: To the previous screen
[]: To the compensation screen
[] / []
[] / []
[] / []
Drawing has been
completed
DROP.POScorrect (L)
PRINT START :ent
PRINTING
PLEASE WAIT
[1]
DROP.POScorrect<ent>
DROP.POScorrect (L)
PATTERN1 = 0.0
:-40 to 40
[FUNCTION],
[] / []
[ENTER]: Drawing
[END]: To the previous screen
[]: To the compensation screen
[1]INK LAYERS
SET UP :HOST
[1]
INK LAYERS <ent>
1 to 9
[FUNCTION],
[] / []