MIMAKI TS34-1800A - General Settings Management

© 2011 MIMAKI ENGINEERING CO.,LTD.
4.1.1 P.1
1
2
3
4
5
6
7
8
R.1.0
4.1.1 Matrix of Operations and Adjustments
When dealing with malfunctions, see “Troubleshooting”.
*
1
Be sure to make adjustment before replacing the main PCB assy.
*
2
See “Chapter4, Technical Information” of “Service Documents”.
Adjustment Items
Work contents
Uploading of Parameters Downloading of Parameters Adjustment of the motor current (4.2.13) Cutter blade position adjustment (4.3.1) Adjustment of output voltage Sensor test (5.1.13) Slant adjustment (4.2.1) Drop position adjustment (4.2.4) Adjustment of Capping Registration of part replacement (4.2.17) Adjustment of the wiper height (4.3.3)
Firmware update*
1,
*
2
Cutter assy removal or replacement

Head PCB assy replacement
Main PCB replacement
*
1
 
X-axis motor assy removal or replacement

Y-axis motor assy removal or replacement

Power supply unit

Head removal or replacement
 
Cap replacement

Pump replacement

Damper

Cutter blade removal or replacement

Wiper assy removal or replacement

MAINTENANCE MANUAL > Adjustment Items > Operation Matrix > Matrix of Operations and Adjustments
Model TS34-1800A Issued 2011.10.17 Revised F/W ver. 1.20 Remark
1.0
Rev.