MIMAKI TS34-1800A - Page 89

© 2011 MIMAKI ENGINEERING CO.,LTD.
4.2.5 P.1
1
2
3
4
5
6
7
8
R.1.0
4.2.5 [HEAD ADJUST] LevelSurfaceCHK
 Function
Draw a pattern to check the horizontal status of the head.
 Procedure
1. Select [LevelSurfaceCHK] from the operation menu to execute
adjustment pattern drawing.
2. Move the head over the platen using the JOG key.
 Explanation of pattern
<LOCAL. 1> [#01]
FUNCTION
#ADJUST <ENT>
#ADJUST
HEAD ADJUST <ent>
#HEAD ADJUST
LevelSurfaceCHK <ent>
#SLANT ADJUST
PRINT START :ent
[FUNCTION]
Adjustment pattern
drawing
#LevelSurfaceCHK
HEAD SELECT :12
Pattern parts that confirm the parallel
of the front and rear parts of the head
against the face of the platen.
It is OK that the dot
position lines up parallel
back and forth.
It is OK that it does not vary
gradually on B->H nozzle
Outward print Homeward Print
70µ(1in/360dpi)
Pattern parts that confirm the parallel of
the right and left parts of the head against
the face of the platen.
Platen Platen
A line UNI/BI misalignment Line 70 µ m misalignment dot position print
MAINTENANCE MANUAL > Adjustment Items > Adjustment Function > [HEAD ADJUST] LevelSurfaceCHK
Model TS34-1800A Issued 2011.10.17 Revised F/W ver. 1.20 Remark
1.0
Rev.