MIMAKI TS34-1800A - Safety Precautions; Symbols and Their Meanings

To Next Page

To Previous Page

1.1.3 P.1

R.1.0

1.1.3 Initial Machine Operation

 Indication on LCD

 Processing sequence

Step

Processing Description

Indication

on LCD

1 Detection of a station origin 1. Drive the wiper motor to detect the station origin.

• When it cannot be detected, [ERROR46 WIPER] is displayed and

the system goes down.

• If an error occurs during the service mode, try the operation again

by pressing the key [ENTER]. Pressing the key [FUNCTION] is

also workable.



2 Detection of the Y origin 1. Drive the Y-axis motor to detect the Y origin.

• When it cannot be detected, [ERROR51 Y-ORIGIN] is displayed

and the system goes down.

3 Capping 1. Move the head carriage back to the Y origin and carry out capping.

A display at the start of the operation

PLEASE WAIT

MAINTENANCE MANUAL > Operating Principle > Basic Operation > Initial Machine Operation

Model

TS34-1800A

Issued

2011.10.17

Revised F/W ver.

1.20

Remark

1.0

Rev.

Other manuals for MIMAKI TS34-1800A