© 2011 MIMAKI ENGINEERING CO.,LTD.
4.2.6 P.1
1
2
3
4
5
6
7
8
R.1.1
4.2.6 EDGE ADJUST
Function
Adjust the width of the each dead space of the right and left ends of the media.
Enter the actual measurement from the media edge to the pattern to the adjustment value. If the unit was changed to
inch, adjust by converting it to inch.
Is used when the system parameter has been initialized or the (plot areas at both ends) are not in the right place.
Procedure
1. Select [EDGE ADJUST] from the operation menu.
2. Draw an adjustment pattern.
[]: Set adjust values of L and R to default
(25.0 mm).
[]: Execute media width detection to draw an
adjustment pattern.
[]: To the screen for adjustment (Without
drawing)
3. Check the adjustment pattern.
4. Enter the adjustment value.
For adjustment, input actual values obtained by measuring from
the edge of the media to the pattern.
Adjusting value: 0.0 to 45.0 mm (unit: 0.1 mm)
(Use the inside of pinch roller as a positive (+). The backlash of
the pinch roller may produce an error of approx. ± 0.5 mm.)
[]/[]: Changes adjustment values.
[END]: Cancellation of input
<LOCAL.1> [#01]
FUNCTION
#ADJUST <ENT>
#ADJUST
EDGE ADJUST <ent>
[FUNCTION]
#EDGE ADJUST
CLEAR < > PRINT
Pattern drawing
#EDGE ADJUST
L=25.0 R=25.0
The set value is saved in the system parameter No.2
R GRIP and No.3 L GRIP as "current parameter
value + (25 mm - input value)".
MAINTENANCE MANUAL > Adjustment Items > Adjustment Function > EDGE ADJUST
Model
TS34-1800A
Issued
2011.10.17
Revised
2012.03.01
F/W ver.
1.20
Remark
1.1
To Next Page
Loading...
