MIMAKI TS34-1800A - Maintenance Precautions; Cleaning Solution Usage

© 2011 MIMAKI ENGINEERING CO.,LTD.
4.2.7 P.1
1
2
3
4
5
6
7
8
MAINTENANCE MANUAL > Adjustment Items > Adjustment Function > MEDIA COMP.2
Model TS34-1800A Issued 2011.10.17 Revised F/W ver. 1.20 Remark
1.0
Rev.
R.1.0
4.2.7MEDIA COMP.2
 Function
Compensates basic feeding amount of media. (Provides a baseline value for user compensation value.)
Is used to adjust the media feed amount when the parameter has been initialized or user compensation value is too large.
 Procedure
1. Select [MEDIA COMP.2] from the operation menu.
2. Draw an adjustment pattern.
[ENTER]: Executes drawing.
[]: To the screen for adjustment
(Without drawing)
[END]: Completes drawing and inputs compensation
value.
3. Check the adjustment pattern.
4. Enter the compensation value.
Compensation value: -500 to 500
[]/[]: Changes adjustment values.
[END]: Cancellation of input
Draw by 2 Heads and feed by 2 Heads at a time.
(1)
(2)
(3)
<LOCAL. 1> [#01]
FUNCTION
#ADJUST <ENT>
#ADJUST
MEDIA COMP.2 <ent>
#MEDIA COMP.2
PRINT START :ent
Pattern drawing
Patterns are plotted repeatedly.
(Click [END] to end plotting.)
A pattern having width
of media is drawn.
Resolution is 720 dpi.
Compensation value is
too large.
Compensation value is
too small.
#MEDIA COMP.2
VALUE = 0
In actual feeding amount compensation, compensation
value for each media set in the SETUP function are
added to this compensation value.