MIMAKI UJF-3042 MkII - Page 3

ii
Turning the Power ON....................................................................... 2-3
Turning the Power OFF..................................................................... 2-3
Setting the media .........................................................................2-4
Set the media in another method ...................................................... 2-6
Test printing .................................................................................2-7
Perform test printing with the test pattern for checking white ink ...... 2-8
Head Cleaning .............................................................................2-8
About head cleaning.......................................................................... 2-8
Perform head cleaning depending on the test printing result ............ 2-8
Printing an image from source data .............................................2-9
Starting the printing operation ........................................................... 2-9
Interruption of printing ....................................................................... 2-9
Checking printing data that is being received or has been received 2-10
When [! WORK High] is displayed................................................... 2-10
If you open the cover during printing ............................................... 2-10
Chapter 3
Setup
About Head Height MENU ...........................................................3-2
Head Height MENU table .................................................................. 3-2
Setting the Media Thickness ............................................................. 3-3
Setting the HEAD GAP...................................................................... 3-3
Gap check ......................................................................................... 3-3
Table spacer...................................................................................... 3-4
About ORIGIN SETUP MENU .....................................................3-5
ORIGIN SETUP MENU table ............................................................ 3-5
Setting the X offset (REM)................................................................. 3-6
Setting the Y offset (REM)................................................................. 3-6
Setting the X offset (LOC) ................................................................. 3-6
Setting the Y offset (LOC) ................................................................. 3-6
Setting the Z origin ............................................................................ 3-7
Changing the origin using the JOG keys........................................... 3-7
About SETUP MENU ...................................................................3-8
SETUP MENU table .......................................................................... 3-9
Setting of Media Correction............................................................. 3-10
Setting of LOGICAL SEEK .............................................................. 3-10
Setting of INK LAYERS ................................................................... 3-11
Setting of REFRESH LEVEL........................................................... 3-11
Setting of UV MODE ....................................................................... 3-11
Setting of UV AdjVal........................................................................ 3-11
Setting of WORK CHANGE............................................................. 3-11
Setting of FAN MODE ..................................................................... 3-12
Setting of AUTO CLEANING........................................................... 3-12
Setting of PRINT FLUSHING LEVEL .............................................. 3-13
Setting of MAPS4 ............................................................................ 3-13
Setting of the Misregistration adjust ................................................ 3-14
Setting of LT mode .......................................................................... 3-15
Setting of SUCTION WIPER ........................................................... 3-15
Setting of Scan Speed..................................................................... 3-15
About MACHINE SETUP MENU ................................................3-16
MACHINE SETUP MENU table ...................................................... 3-17