MIMAKI UJF-3042 MkII - Setting of LT Mode; Setting of Scan Speed; Setting of SUCTION WIPER

3-15
Chapter 3 Setup
3
2
2
2
Setting of LT mode
1
Press the (MENU) key in the local
mode.
2
Press to select "Setting", then
press the key.
• The setting menu is displayed.
3
Press the
(>>)
.
4
Press to select “LT mode” , and
press the key.
5
Press to select a set value, and
press the key.
• Set value :ON / OFF
6
Press the key several times to
end the setting.
Setting of SUCTION WIPER
Set the head that executes WIPING AFTER PRINT and
the execution interval.
1
Press the (MENU) key in the local
mode.
2
Press to select "Setting", then
press the key.
• The setting menu is displayed.
3
Press the
(>>)
.
4
Press to select “SUCTION
WIPER” , and press the key.
5
Press the key.
• WIPING AFTER PRINT menu is displayed.
6
Press the key.
• SELECT HEAD menu is displayed.
7
Press to select the heads for
WIPING AFTER PRINT, then press
(
 )
.
• Only heads with check boxes selected will be
suction-wiped after printing.
• Head 4 (Head 3 with 3042MkII) is always
selected.
8
Press the key.
9
Press to select “EXEC
INTERVAL” , and press the key.
10
Press the key.
• EXEC INTERVAL setting menu is displayed.
11
Press to select the set value, and
press the key.
• Set value: FILE/WORK CHANGE
• When set value is set to "FILE", proceed to Step
12. Otherwise, proceed to Step 14.
12
Press to select “Interval” , and
press the key.
13
Press to change interval , and
press the key.
• Set value: 1 to 5
14
Press the key several times to
end the setting.
Setting of Scan Speed
1
Press the (MENU) key in the local
mode.
2
Press to select "Setting", then
press the key.
• The setting menu is displayed.
3
Press the
(>>)
.
4
Press to select “Scan Speed” ,
and press the key.
5
Press to select a set value, and
press the key.
• Set value : STANDARD / LOW
6
Press the key several times to
end the setting.
• Since UV light intensity adjustment is performed,
check the print performance (stickiness, odor etc.)
before using the LT mode.
• Effective condition
Ink type Resolution Pass Media
LUS120 600 x 600 8 pass UV PET
• When the set value is set to "FILE", wiping after
print will only be performed at set intervals.
• When the set value is set to "WORK CHANGE",
wiping after print will only be performed at the time
of work change.