MIMAKI UJF-7151 plus Requests For Daily Care And Maintenance

3
4. Notes for working environment
Performing frequency of the print setting or maintenance is greatly influenced by the printing environment or
the condition of the media used. Use this machine with a full understanding of the followings.
5. Storage of media
Media should be stored in the little dust area, and not in direct sunlight. Avoid storing the media in the area
with high temperature and high humidity.
6. Storage of ink bottle
Be careful of the followings to store.
• Store the ink bottle in no direct sunlight, and no high humidity.
• As it's a delicate product, do not drop it.
• Ink IC should not be contaminated and discharged static electricity.
• Be sure to store the ink bottle and the ink IC together.
Working environment Consideration
In the gritty and dusty place
 To keep the nozzle face clean, set to wipe periodically. (Operation
Manual Chapter 4 “Setting Interval wiping”)
 Change the setting of periodic wiping depending on the amount of
dust.
When the head gap is set wide
because fibers stick out of media
 UV light can expose the nozzle when there is a lot of scattered mist.
Raise the refreshing level for drawing (Operation Manual Chapter 3
"Setting of REFRESH"), and set the periodic wiping ( Operation
Manual Chapter 4 “Setting Interval wiping”).
 Increase performing frequency of every maintenance.
When the media that reflects UV
light well is used such as glasses
or glazed metal
When there is an
infrequentlyused ink (print head)
 An infrequently-used print head can be unstable to discharge ink
comparing with the other print heads. Raise the refreshing level for
drawing (Operation Manual Chapter 3 "Setting of REFRESH") to
raise the usage rate of the head.
When printing on the media on
which static can be charged
 Put humidifiers on to avoid charge. Static may collect mist or dust
around the printing area or the head. To print continuously for a long
time, set the periodic wiping. (Operation Manual Chapter 4 “Setting
Interval wiping”)
When printing in a dry place (such
as in winter)
When printing on a markedly
uneven media (or object)
 To keep the head gap the same, set extra media outside the suction
area where a printing media is set. Leaving the head that has been
degraded by reflected light may cause failure that needs replacing of
the head.
Ink bottle and Ink IC

MIMAKI UJF-7151 plus Specifications

General

Brand	MIMAKI
Model	UJF-7151 plus
Category	Printer
Language	English