Mindray Accutor 7 - Disassembling the Main Bracket Assembly

98 pages

Save Page as PDF

To Next Page

To Previous Page

6-6

6.3.5 Disassembling the Main Bracket Assembly

1. For monitors without a multi-function connector, use a flat blade screwdriver to

gently lift the cover release on the inside of the unit, and then remove the cover.

Cover

Main Page

Table of Contents7
Introduction11
Manual Information11
Safety Information11
Warnings12
Cautions12
Notes12
Equipment Symbols12
Theory of Operation13
Overview13
Connectors for Peripheral Devices14
Main Unit14
Front Housing Assembly16
Main Board16
Rear Housing Assembly17
External Module18
Equipment Installation19
Unpacking the Equipment19
Preparation for Installation19
Preparation for Installation Site19
Environmental Requirements19
Electrical Requirements20
Equipment Installation20
Preparation for Power on21
Testing and Maintenance23
Introduction23
Performance Tests23
Performance Test Frequencies24
Visual Inspection24
Spo Test24
NIBP Test26
CO Test (Only Available for Accutorr 7)29
Exergen Temporalscanner Thermometer Test31
TM Module Test31
Electrical Safety and Other Tests32
Electrical Safety and Other Test Frequencies32
Electric Safety Tests32
Power-On Test32
Touchscreen Calibration33
Recorder Check33
Bar Code Scanner Test33
Battery Check34
Nurse Call Reply Performance Test34
Factory Maintenance35
Accessing Factory Maintenance Menu35
Drawing Waves35
Software Version36
Monitor Information37
Troubleshooting39
Overview39
Part Replacement39
Checking Equipment Status39
Checking Software Version39
Checking Technical Alarms40
Troubleshooting Guide40
Power On/Off Failure40
Display Failures41
Alarm Lamp Failures42
Button and Encoder Failures42
Sound Failures43
Battery Failures43
Recorder Failures44
Output Interface Failure45
Data Storage Failure45
Wired Network Related Problems46
Wi-Fi Related Problems (Only Available for Accutorr 7)47
Module Defective47
Exergen Temporalscanner Thermometer Module Problems48
Module Problems (Only Available for Accutorr 7)49
Technical Alarm Messages49
Disassembly and Repair51
Tools Required51
Preparations for Disassembly51
Disassembling the Main Unit52
Disassembling the Temperature Module (Optional)52
Removing the Recorder53
Separating the Front and Rear Half of the Monitor53
Removing the Parameter Connector Panel Assembly55
Disassembling the Main Bracket Assembly56
Removing the Parameter Board (Spo Optional) and Power Management Board58
Removing the Parameter Connector Panel Assembly (with CO Only Available for Accutorr 7)59
Disassembling the CO60
Disassembling CO2 Main Module (Only Available for Accutorr 7)60
Disassembling the Main Bracket Assembly (with CO , Only Available for Accutorr 7)61
Disassembling Pumps and Valves62
Disassembling AC/DC Power Board and Battery Converter Board62
Disassembling the Front Housing Assembly63
Removing the Touchscreen Control Board63
Removing the 2.4G Wi-Fi Module (Optional, Only Available for Accutorr 7)64
Removing the 5G Wi-Fi Module (Optional, Only Available for Accutorr 7)6-1565
Removing the Main Control Board67
Removing SD Card67
Removing the Touchscreen68
Disassembling the Display68
Removing the Keypad69
Removing the Encoder69
Removing the Alarm Lamp69
Disassembling the Smartemp70
TM Module (Optional)70
Removing the Smartemp70
Disassembling the Temperature On-Position Detection Board PCBA71
Disassembling the Exergen Temporalscanner Themometer Module (Optional)6-2272
Parts75
Introduction75
Main Unit75
Exploded View75
Parts List76
Front Housing Subassembly (Touchscreen)77
Exploded View77
Parts List78
Rear Housing Assembly79
Rear Housing Assembly81
Main Bracket Assembly83
Exploded View83
Parts List83
Power Management Board Assembly84
Parts List84
Exploded View84
Parts List85
Parameter Connector Panel Assembly85
Exploded View86
Parts List86
Predictive Temperature Assembly87
Exploded View87
Parts List87
Exergen Temporalscanner Thermometer Assembly88
Exploded View88
Parts List89
Exergen Frame Assembly90
Exploded View90
Parts List90
Hardware and Software Upgrade91
Hardware Upgrade91
Upgrade Package91
Upgrading Parameter Modules91
Upgrading Temperature92
Upgrading Wi-Fi (Only Available for Accutorr 7)92
Enabling Parameter Functions93
Software Upgrade93
A Electrical Safety Inspection95
Power Cord Plug95
Device Enclosure and Accessories96
Device Labeling96

Mindray Accutor 7 - Disassembling the Main Bracket Assembly

Table of Contents

Related product manuals