1
Accutorr
®
Quick Reference Guide
KEYS
Power ON/OFF Switch
• Press this key to turn the monitor on.
• If no parameter is being measured, press this key to enter
Standby mode.
• When the monitor is on, press and hold this key for more than 2
seconds to turn the monitor o.
An indicator is built into this switch. It turns green when the
monitor is on, it turns yellow when the monitor enters Standby
mode, and it turns off when the monitor is off.
Clear Key
• In the Measurement mode, press this key to clear current
parameter value and error codes.
• In the Measurement mode, press and hold this key for more
than 2 seconds to access Parameter Setup mode.
• To enter the Maintenance mode, turn the power on. At the rst
audible beep, press and hold the Clear key.
NIBP Start/Stop Key
• In the Measurement mode, press this button to start or stop
NIBP measurement.
Patient Category Key
• In the Measurement mode, press this key to toggle between
adult, pediatric and neonate.
PATIENT SIZE
The Accutorr 3 monitor allows the clinician to adjust patient size.
To adjust patient size, press the hardkey.
Note:
Adjusting patient size restores the monitor to the default (preconfigured) settings
but does not clear patient information or data.
To Next Page
Loading...
