8
BeneVision N22/N19/N17/N15/N12
Quick Reference Guide
c. Select Print.
Adjust Printed Waveforms
To adjust the waveforms printed for a patient on the N Series bedside monitor:
a. Select the Main Menu
quick key, and select Report Setup from the
Report column.
b. Select Realtime Reports tab.
c. Select Current Waveforms.
d. Select Print.
To print selected waveforms for a patient on the N Series bedside monitor:
a. Select the Main Menu
quick key, and select Report Setup from the
Report column.
b. Select Realtime Reports tab.
c. Select Selected Waveforms.
d. Select the desired waveforms to add/delete from the selected list.
e. Select
to return to the previous page
f. Select Print.
End Case Report
The following reports can be set as end case reports:
• ECG Report
• Realtime Report
• Tabular Trends Report
• Graphic Trend Report
If Print End Case Report are enabled, the N Series bedside monitor will
automatically print the selected reports when a patient is discharged.
To set reports to print as an End Case Report:
a. Select the Main Menu
quick key, and select End Case Report from the
Report column.
b. Select the desired report tab.
c. Enable Set As End Case Report.
To Next Page
Loading...
Need help?
General
