P/N: H-046-007060-00 Rev 3.0
6
BeneVision TD60 Quick Reference Guide
PATIENT SETUP
Admit
When admitting a TD60 for the first time, the device must be admitted to the
system through the CMS.
After first admitting the device to the CMS, you can directly admit the next
patient on the TD60 by discharging the previous patient, and then pressing
to admit a new patient.
Discharge
Discharging the patient will stop monitoring, clear patient information, and
restore default (preset) settings on the TD60.
A patient can be discharged by selecting the Discharge Patient menu, and
then selecting that a new patient is on the TD60.
Note: Discharging the patient on the TD60 discharges the patient from the
CMS.
Select the Discharge Patient menu
1. Press to enter the main menu.
2. Tap Discharge Patient.
3. Select Yes.
• The patient is discharged from both the TD60 and the CMS.
• The patient's configuration is cleared and the configuration is restored
to the saved user configuration or factory default configuration.
• The patient will be added to the discharged patients list at the CMS.
4. Press to admit a new patient.
Adjust Patient Category
The Patient Info menu allows the clinician to adjust the patient category.
Note: Ensure the patient category selection is appropriate for the patient
before monitoring begins. The supported patient categories are Adult
and Pediatric.
To Next Page
Loading...
Need help?
General
