P/N: H-046-007060-00 Rev 3.0
15
BeneVision TD60 Quick Reference Guide
Unpair a TD60 with a BP10 via the TD60
Option 1:
1. Press to enter the main menu.
2. Tap Wireles Modules.
3. Select the device you wish to disconnect from the TD60 from the
devices list under Devices and tap Disconnect.
The connected device is disconnected from the TD60.
Option 2:
1. Press to enter the main menu.
2. Tap Wireles Modules.
3. Disable MPAN.
Unpair a TD60 with a BP10 via the BP10
1. Press the MPAN key on the BP10.
2. Select Yes when the prompt message “Are you sure you want to close
MPAN and unpair BP10?” appears.
Caution: Before moving a TD60 or BP10 to another area, unpair them first.
Caution: Before admitting a new patient at a BP10, you need to unpair it with
a TD60 first.
TECHNICAL ALARMS
Alarm Reset
To silence an alarm for the duration of the alarm on the TD60 and the CMS:
1. Press to enter the main menu.
2. Tap Alarm Reset from the Commands section.
OR
To Next Page
Loading...
Need help?
General
